Skip to content
Leak Locators East Coast

Service

Slab leak detection

A slab leak is a supply or drain line losing water underneath a concrete floor. The damage shows up long before the cause does — a warm patch of floor, a water bill that climbs for no reason, the sound of running water with everything turned off. Locating it accurately is the whole job, because the alternative is opening concrete to look. This service is offered in Florida.

A technician holding a thermal imaging camera with the screen visible, aimed into a tiled shower

Find it before anything is opened

Lines are isolated and pressure-tested so the loss can be narrowed to a specific run rather than a room. A line that holds is ruled out, and ruling out is as useful as finding.

Acoustic listening and thermal imaging then locate the point itself through the slab. The output is a marked location, so whoever does the repair opens one area rather than searching — which is the difference between a patch and a floor.

A technician in headphones holding a ground microphone against a tiled floor, an acoustic amplifier on a shoulder strap

Signs of a slab leak

Any one of these is worth a call. Several together usually means a line under the slab.

A warm spot on the floor
A hot-water line losing water under the slab warms the floor above it.
The water bill climbing
A rise with no change in usage is water going somewhere it is not being used.
Running water with everything off
Audible flow when no fixture is on points at a line that is not holding.
Damp or lifting flooring
Moisture surfacing at the slab edge, or flooring lifting with no spill to explain it.
Low pressure
Pressure that has dropped off without an obvious cause can be loss upstream of the fixtures.
Cracks in the slab or walls
Long-running loss under a slab can move the ground beneath it. Worth ruling out.

Tell us what it's doing.

Describe what you are seeing and we will tell you what it sounds like and what a visit would involve. If it is dropping fast, call. You will reach a three-person, owner-led team.

Questions people ask

Do you have to break the floor to find it?

Not to find it. Locating is non-invasive — pressure isolation, acoustic listening and thermal imaging. Opening concrete is a repair step, and only once the location is known.

Is slab leak detection available in North Carolina?

No. This service is offered in Florida. In North Carolina we cover pool and underground leak detection.

What do I get at the end?

A marked location and written findings on the invoice, so whoever carries out the repair knows where to open rather than where to start looking.

How is this different from underground leak detection?

Underground work is lines in the ground outside the structure. A slab leak is under the concrete floor of the building itself. The equipment overlaps; the access problem does not.

Call (919) 633-4975